Daily Home Use Instructions
step 1: Cleanse Your Face Thoroughly
Start with clean, dry skin.
- Remove all makeup, SPF, or skincare products to allow better light penetration.
- Pat dry gently — no toners, acids, or occlusives before the session.
step 2: Choose the Right Light Mode
:Use the appropriate light setting based on your skin goals:
- Light Mode Use For Session Time
- Blue Light Acne, inflammation, oily skin 10–15 minutes
- Amber Light Fine lines, dull tone, redness 10–15 minutes
- Red + Infrared Wrinkles, sagging, collagen boost 15–20 minutes
- Mixed Mode Combination skin, acne + aging 15–20 minutes
(Your practitioner may adjust this based on your skin condition.)
step 3: Position the Mask Comfortably
- Place the FiberLift mask securely on your face using the provided straps.
- Ensure close contact without gaps to maximize light absorption.
- Relax in a sitting or reclined position for the session.
step 4: Start the Treatment
Power on the device and select the desired mode.
- The mask will remain cool and comfortable throughout the session thanks to its honeycomb matrix and passive heat dissipation.
- The dual-circuit system ensures uninterrupted performance — even if one section fails, treatment continues.
step 5: After Treatment Care
- No rinsing needed.
- Apply a gentle serum or moisturiser to seal in hydration.
- Use SPF if applying during daytime, especially if using red or amber light.
Recommended Routine
- Daily use: For ongoing treatment (10–20 minutes daily depending on mode)
- Minimum frequency: 3–5 times per week for visible results
- Full course: 4–8 weeks for best outcomes; continue long-term for maintenance
Important Safety Notes
- Do not exceed 20 minutes per session
- Suitable for all skin tones and types
- Safe for pregnant or breastfeeding women, but always check with your provider
- Avoid use on open wounds, severe skin infections, or active eczema
- Do not look directly at the light – use with eyes closed or protective goggles